ECO PH METER

PH600 gives a quick measurement of accurate values : Range : 0.0 14.0 pH Resolution : 0.1pH Accuracy : 0.1pH, use in temperatures : 0 50ºC. The PH600 economic PH meter is used in sectors as diverse as : Agriculture, hydroponics, home culture, fish farming, aquarium culture, swimming pools, laboratories, education, food ... How the PH600 economic PH meter works: Remove the black protection and turn on the meter. Immerse it up to the limit and wait a few seconds for the data to stabilize. After use, pass the electrode through water to keep it clean. Preserve the electrode by placing a few drops of MA9015 storage liquid or ph 7.0 calibration liquid on the cap with a sponge. Always replace the cap after use. DO NOT use distilled or deionized water for storage. Large reading differences of ( 0.5 pH) may be due to need for calibration, dry electrode or low batteries; Calibration of the pH meter The calibration procedure is simple and quick Immerse the electrode to the limit in pH 7.01 calibration liquid (M10007) Wait a few seconds for the data to stabilize and adjust to pH 7.0 with the screwdriver to the screw on the back. The meter is calibrated. ALWAYS USE new calibration liquids. Maintenance : Always make sure that the electrode is clean : To do this, rinse the electrode in tap water after each use; To remove accumulated dirt, lightly brush the glass bulb and the transparent tape with a soft toothbrush with a drop of liquid soap. Also, every 3 months, it is good to give the PH electrode of the PH600 PH meter a bath in a sachet of cleaning liquid (ref: M10016B) for 2 hours. Battery replacement: When the PH 600 pH meter cannot turn on or loses intensity, open the battery compartment and replace the 3 1.5V batteries, respecting their correct polarity. Good measurement!